RE450 V2 Ocassionally blinking red
RE450 V2 Ocassionally blinking red

What does it mean when the range extender occasionally flashes red. It only flashes red once (easy to miss) but then is solid blue for some time, before flashing again.
I reset to factory settings and set up again. I updated the firmware. Still seeing the same problem.
Also, whe I walk with my device from my living room which is probably using the host network for internet, and into my bedroom to use the extended network, the internet fails. I have to reset lease and it works. Can you advise on what to do about that as well?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi Lucy
I still have and use the RE450 V2
But as it seems that many more more people are having the same issue, maybe a positive answer about the red flashing issue would be useful? At the very least the meaning of it, which is not mentionned in the instructions.
Would'nt you think so?
And would't it be possible to have the answer a little faster, if possible ?
- Copy Link
- Report Inappropriate Content
I realise this problem is quite dated now but I thought I would offer my experience with the red blinking light.
My light flashed red intermittently but quite often. The connection did not seem to be affected that much.
However I pulled the eithernet cable out and it went solid blue. Therefore for me it was an ethernet connection problem.
I then plugged it back in and no flashing red light..... weird.
Hope this helps.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 29
Replies: 0
Voters 0
No one has voted for it yet.