Home Network Community > Deco > Deco M9 Plus - Channel Bandwidth Configuration and UPNP
< Deco

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M9 Plus - Channel Bandwidth Configuration and UPNP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M9 Plus - Channel Bandwidth Configuration and UPNP
Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-03-06 04:44:00
Model: Deco M9 Plus  
Hardware Version: V1
Firmware Version: 1.3.0 Build 20190821 Rel. 54023

Good evening.

 

Fired up a set of P9 Plus units today and am happy with the wireless performance. 

 

Sub-second roaming hand-off rocks!

 

I don't like stepping on my neighbors with 40 MHz spread on 2.4 MHz channels, and not being able to disable UPNP concerns me. 

 

Is it possible to manually change the channel bandwidth and disable UPNP?

 

Is Terminal (Telnet, SSH) an option to configure the devices manually?

 

Until then I'll likely put the P9's in AP only mode and put them behind an independent gateway.

 

THX

 

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-03-06 12:14:49

@Teknowolff 

 

Hello, there is no option to change wireless channel width, and it does not support telnet or SSH.

 

The UPnP option is enabled by default. and this new feature to toggle it on/off will be added with firmware upgrade. 

 

Good day. 

 

  0  
  0  
#2
Options
Re:Deco M9 Plus - Channel Bandwidth Configuration and UPNP
2020-10-02 18:24:19

@Kevin_Z 

I have the same issue with the newer deco X20.

Upnp is enabled by default and there's no option to disable it.

Do you have any feedback about when this option will become available?

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 2

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.