Home Network CommunityDSL Modem&RoutersBandwidth Control / QoS
DSL Modem&Routers

Bandwidth Control / QoS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bandwidth Control / QoS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bandwidth Control / QoS
Bandwidth Control / QoS
2019-11-05 21:46:20 - last edited 2020-01-11 12:05:09
Model: Archer VR900v  
Hardware Version: V2
Firmware Version:

Hi

Is there a way to enable bandwidth control on my model?  or qos only for guests?  I switched from vr600v to vr900v 2.0 in my bar and notice that in the evenings when there are still 20-30 people in the WiFi, not much is left for me.  I think it's a shame because the vr900v 2.0 was very expensive and now such an important feature is missing.  maybe I just can not find this function.

0
0
#1
1 Accepted Solution
Re:Bandwidth Control / QoS-Solution
2019-11-07 06:42:46 - last edited 2020-01-11 12:05:09

@Fin 

 

I see, while I'm sorry to tell you that QoS won't allow us to define an exact value for the specific clients; instead, we can setup different priorities for them. 

 

Below is the instruction to setup QoS. 

https://www.tp-link.com/support/faq/1742/ 

Recommended Solution
0
0
#4
3 Reply
Re:Bandwidth Control / QoS
2019-11-06 06:35:50

@Fin 

 

The QoS has the similar function as the bandwidth control, the router supports either bandwidth control or QoS. 

 

Back to your case, actually you can use access control to satisfy your needs. 

 

You can add the devices allowed to access internet into whitelist, and then other devices won't be able to access internet. 

https://www.tp-link.com/support/faq/1009/  

 

Or you can add the blocked access devices into blacklist. 

 

May it help.

0
0
#2
Re:Bandwidth Control / QoS
2019-11-06 09:13:40

@Kevin_Z 

 

Thank you for your answer but I think so I can not do that.  The blacklist blocked completely.  i can not lock my guests in the evening.  I would like to set it 50% for me and 50% for guests.  I would like to define an exact value (Mbit) for the guest WiFi.

0
0
#3
Re:Bandwidth Control / QoS-Solution
2019-11-07 06:42:46 - last edited 2020-01-11 12:05:09

@Fin 

 

I see, while I'm sorry to tell you that QoS won't allow us to define an exact value for the specific clients; instead, we can setup different priorities for them. 

 

Below is the instruction to setup QoS. 

https://www.tp-link.com/support/faq/1742/ 

Recommended Solution
0
0
#4

Information

Helpful: 0

Views: 12

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.