Hello,

Archer C60 V2 supports QoS only, which can not setup certain bandwidth for specific device, while we can setup different priority levels for the client devices. 

Below is the instruction: https://www.tp-link.com/en/faq-1532.html

May it help. Good day. 

@Kevin_Z 

Kevin_Z wrote

Hello,

 

Archer C60 V2 supports QoS only, which can not setup certain bandwidth for specific device, while we can setup different priority levels for the client devices. 

 

Below is the instruction: https://www.tp-link.com/en/faq-1532.html

 

May it help. Good day. 

Hi  Kevin, the old versión of QoS (Bandwidth Control) is better. The new QoS don't works.

QoS si a problem and it's filter is bad. 

I Always use Tplink and Bandwidth Control tools between Address Reservación are a good option but now I can't use it.

@Avinashk  @Wayo    

Hello, thanks a lot for your valued suggestions.

Currently, the Archer C60 doesn't support the Bandwidth Control feature but only supports QoS. This will be forwarded as a feature request to our developers for consideration.

Thank you again for your feedback.

yeah I agree bandwidth controller should bring back to new OS on tplink router at least to Archer C60 which I using right now.

@AoiTenshi 

Thank you for your suggestions again. As we responded earlier that this is noted, we will be forwarded as a feature request to our developers for consideration, we hope you could wait and pay attention to the official website for any future firmware updates.

Good day.

@Kevin_Z 

I too am upvoting this. Bought a new router today to find out that my old router is better? I need bandwidth control, will a firmware upgrade work?