I have two CPE210 devices as a bridge between two buildings, about 125 feet apart. Signal strength on client -40db. SNR 68db. I can run the speedtest tool and get 160 Mbps. One the AP side, on a compu

I chose this router just because of the load-balancing feature. I have a fast primary connection and a backup (slow) VDSL – just because the main line has problems and goes offline too often, couple o

TL-SG108E Ethernet connection is down on iMac OSX Mojave 10.14.6. The Ethernet port on the iMac works fine with TL-SG105 but the link is down when connected to TL-SG108E. Ports on both TL-SG108E and t

I use GRC.com to test ports externally for stealth. When using TL-R600VPN in bridge mode (PPPoE), the test for stealth shows 2 out of 3 for response, the router still responds to "solicited" packets.

Hello, i have 3 switches on a small network - all switches have a valid static ip address I have 2 TL-SG1016PE they work fine when connected to the router but the TL-SG108e will only work if it is dai

I can connect my laptop to the CPE210 using an ethernet cable as per instructions (set laptop address to 192.168.0.1, connect to 192.168.0.254). The web pages all look as described. I configured the C