My EAP235-Wall is showing up as 100M and not 1000M as promised in the product specification. It's connected to a Cisco 3750G gigabit switch. Any settings that I must enable on the EAP235-Wall side to

Hello, I was wondering that I cannot see the users/clients connected via VPN, is it possible that this is not implemented ? My router is TL-R605. Also via VPN (L2TP in my example) is not implemented t

Hello After using the recent upgrade of Firmware 1.7.1 Build 20201016 Rel.62818 for my OC200 Controller in SDN encounter several issue, two of my EAP225 outdoor suddenly go to isolate mode and failed

I'm trying to use this switch's PoE function to power TL-WA1201 V2 AP. The AP doesn't turn on any of the 1-8 PoE enabled ports. It works with its included PoE injector over the same cable. I even test

Had two of these for a number of years, to connect two buildings and worked flawlessly. However, recently changed the IP address within them due to moving to a new subnet - i.e instead of 192.168.1.xx

I know very little about networking, just enough to plug things together... and troubleshooting using info online is complicated by the fact I'm on a Mac (I'm no good with Windows). I followed the CPE