I'm currently running controller 4.4.3 with this switch (and some EAP225s) and notice that the switch is not in the 4.4.4 supported hardware list. Is that an oversight in the release notes or has supp

T1700G-28TQ V3 All settings default except: VLAN 1 interface ip 192.168.1.1 255.255.255.0 port 1/0/1 VLAN 10 interface ip 192.168.10.1 255.255.255.0 PVID 10 port 1/0/2 PC1 conected to port 2 ip 192.16

Although I haven't tested this, I'm using my switch as an L2 switch and expect the ports can operate at line rate. Will port-to-port forwarding performance reduce if I start using it as a L3 switch an

TP-Link New Safestream Router, Jetstream Switch, and Omada AP can be managed by Omada SDN Controller. For some Old Jetstream Switches, discussed here, we have released the new firmware to fit for Omad

I'm getting an EAP225 replaced under warranty but couldn't find any information on provisioning it with the config from the one being unprovisioned. Any suggestions for a seamless transition? I'm usin

I have two EAP225s configured the same way with wired backhaul but one of them loses connection to the SDN controller every few days and I have to power cycle it to re-establish connection. Both are p