Got it.That's the limitation I was mentioning about. TP-Link devices only support L2 LAGG. You are targeting IEEE 802.3ad (Dynamic) Link Aggregation (LACP, 802.1AX) which unfortunately is not...

@Fex I would try Adaptive Load Balancing or Balance XOR to see if that can achieve the goal - see that thread.

By definition Static LAGG is defines as - "Balances outgoing traffic across the active ports based on hashed protocol header information and accepts incoming traffic from any active port. This is a...

@arimal199 Does your router booting at all ? Is there any leds lit when started ? Have you tried to go through TFTP method to recove it ? If nothing helps then you should contact local tp-link...

Nothing unusual in that log. If that issue has presented itself (as you mentioned) after a FW upgrade, try to hard reset (Method 1) the router and then configure from scratch. Take notes about your...

@esprit You should connect your sky er115 to Internet port of the AX10 (use one of the ethernet ports on sky er115). Now if you use your sky er115 as modem only (bridge mode), you can leave the AX10...