Dear @waldi.top, After the firmware recovery, what are the LED indicators on your OC200? Are the LEDs for ethernet ports still blinking even if there is no cable plugged into your OC200? Are you...

Dear @donmartino77, donmartino77 wrote I noticed that the Omanda SDN does not always display correct results. Example: I have a client01 which is directly connected to the switch port 10. The switch...

Dear @Dillius, Dillius wrote @Fae I think the confusion is that I did not know about this device password settings before I went ahead and reset the devices. Even if it WAS in the backup, the...

Dear @Larz256, Larz256 wrote @Fae That bring up an interesting point; Once registered, does the controller reach out to devices (push) or do the devices poll into the controller (pull) for...

Dear @riny, riny wrote I'm running a local Linux controller, using the tarball distribution (not deb). I just upgraded my controller from 4.2.0 to 4.4.3 using the "uninstall.sh upgrade" method and...

Dear @Dillius, Dillius wrote I restore a backup to the software controller but it still claims the devices are being managed by another system. I can't adopt them and take them over without some...