Forums/
Controllers
2020-08-17 19:43:44
So I tested today and set same IP on the two APs, but located at two different sites and this all worked beautifully. It will be great if FAQ can be updated to state that remote sites can be all in...
0HELPFULS
Forums/
Controllers
2020-08-17 13:23:11
Thnaks Fae. I am not looking for configuration guides as I have already done so. Just wanted to hear from someone who may have done similar. Configuration guides and FAQs dont state that private Ip...
0HELPFULS
Forums/
WiFi
2020-08-17 12:41:55
Yes, if cable is passing thru some rugged environments and is open air within building or even outside the building (in that case, POE passing surge suppressors needed at least on the switch side and...
1HELPFULS
Forums/
WiFi
2020-08-17 00:36:43
I am just going to add that CAT6 is not necessary for delivering 1Gig speeds. CAT5e can deliver 1Gbps, 2.5Gbps at 100 meters and many can also deliver 5Gbps at 100 meters (depends upon make / model /...
1HELPFULS
Forums/
Controllers
2020-08-17 00:11:07
I have a situation where all remote sites (one AP per site) will be in the same subnet (ISP router default LAN subnet). I tested one AP and it works and joins the controller. I was expecting...
0HELPFULS
Forums/
Controllers
2020-08-11 12:39:59
Thanks, There are few reasons of Internet service being unreliable at the site and we accepted those limitations and then signed off on. And I had said that we did not want to host on EC2 despite it...
0HELPFULS