Hi @tpe, I agree the EAP660HD and firmware are very new. I'd suggest returning it and getting a EAP225V3 for $59 from Amazon to tide you over for the next 6-12 months. While I'd like to upgrade to...

Hi @tpe, What happens if you try to re-configure / re-setup a few of the IoT devices having issues. Or better yet, make a new, additional SSID on 2.4GHz only and join your IoT's to that. I wonder if,...

Hi @ssyed, Hmmmm, not sure about Canadian models/regulations, but here in the USA, these devices (EAP225V3, EAP225-OD, EAP245V3, EAP265) are not approved by the FCC for DFS. I'm not sure what...

Hi @plavielle, Ideally, you would use an RF scanner to scan for interfering signals, But these are rather expensive. You could use a tool like inSSIDER or similar from a PC or Android phone. But this...

Hi @networkgeek21, I recommend using the custom scale for better control. Your 5.8GHz transmit power will need to be higher than for 2.4GHz. I find 80MHz (for 5.8; 20MHz only for 2.4) only gives a...

Hi @tpe, How are you managing the EAP660? Through the Web UI? You may need to enable WPA1/2 for older devices (if it is not already). Many IoT are 2.4GHz, 20MHz, 802.11b/g/n so these features will...