A new version of the Omada App for iOS was release today with SDN support! Seems like SDN release is imminent. FYI, this version of the App seems a little buggy connecting to my OC-200 running v1.2.3...

Hi @rtrevino, A couple things to look at: 1) "My transimt powers are set to low and i have specified 3 different 5ghz channels on this floor. 157,161,149" Are you using 80 MHz BW on 5.8GHz? If so,...

You cannot set/limit the aggregate BW by SSID, only per client. So, aggregate usage will vary by number of clients connected and usage per client.

Hi @TodNeykos, Yes, and Yes. When you create an SSID you can optionally limit the DL and UL BW permitted by each client that joins the SSID. SSID authentication (e.g. WPA, WPA2, Radius, etc.) is...

Hi @Ernieken, For security reasons, I believe you have to go through the direct, internal IP route (e.g. 192.168.1.64 in my case) to connect to the Omada controller and not through the cloud gateway...

Hi @Ernieken, In Omada, if you go to "Access Points" and then Click on "Overview" or "Config" on the right hand side you will see a little up arrow under "Action". This will open the AP Firmware...