@JessieG , We recommend you to configure the mesh network again. Please make sure that you enable mesh on the OC200 first. Then you can do it as the following steps. 1. Connect all EAP devices and...

@trauts14 , From your description, it should be EAP225-Outdoor. When you put it in the secondary WLAN, it doesn't broadcast the SSID. Here are some suggestions for you to have a try. 1. Please check...

@hughLink , We have changed the "SSID Isolation" to "Guest Network" in Controller 3.1.4. With the “Guest Network” enabled, the devices connected in the same SSID of the same AP cannot communicate...

Devinfotech2016 wrote I had installed 23 access point in hotel with Omada cloud controller. But it’s handeling only 60 to 80 client . Need help to solve this I hade use microtik router board and...

@JessieG From the screenshots you sent, we can know that you cannot adopt the EAP successfully. Here are some suggestions for you. 1. Make sure that you input the correct password. From the...

bland328 wrote R1D2 wrote In my opinion it makes no sense to enable U-APSD based on a SSID...it does not help for battery-powered devices, since the AP's radio in power save mode would require a PS...