WBS510 have two antenna interface, so it can connect with two Antennas. But you can only connect with one antenna.

Maybe you can check whether you have enabled the SSID broadcast.

The problem may due to the channel used by EAP120 is too crowded. You can use WIFIanalyzer to scan the 2.4G network and select a clean working channel.

Hi andrea Sometimes the portal login page may no pop up automatically. You can open your browser and input a http link to trigger the protal.

Hi SOLP First of all, make sure that your EAP had gained a correct IP address from the DHCP Server. Or their IP would all be 192.168.0.254 so that the Controller cannot distinguish then. Then make...

Hi Steve There is a serious problem in your topology. Both A and C are in AP mode and had the same SSID. But C is closer to B so B had a higher possibility to connect to C. Then there would be a...