@Shay972 HI, Sorry for the delay. I would like to follow up on your case by email and please have a check of your email box. Thank you very much.

@TP1979 Hi, did you use the Pi-hole IP as the DNS server under IPV4 WAN settings? if yes, it would be the IP conflict that caused the constant changes of the LAN IP address; Deco will use the...

@Mrfunkyburger Hi, it would be better if you could turn off the WIFI of the Plusnet router and only leave the wireless Mesh network of Deco; For the current connection, Deco is also the client of the...

@JoeSchmidt3 Thank you very much for your kind reply. We would like to follow up on your case by email and please have a check of your email box later. Thank you very much.

@excelsioras Thank you very much for your feedback. Have you tried to turn off the Mesh Technology under the device settings on the Deco APP? And did this issue only occur to the wireless devices? or...

@Preyes1 Hi, Since Deco is not the NAT gateway on the access point, so there would be no port forwarding settings on the AP mode; You might need to change the operating mode back to the wireless...