Hi Yos Your Level 4 devices are connected to wireless router? Or get the IP address from R470T+? If they are connected to R470T+, maybe you should consider to set DHCP reservation for them, then set...

Hi Yos It's me again. Could you tell me how's your failure? It's physical disconnected or just lost internet? It's a little long to take more than 1 minute. This may also related to whether your...

@pt33 As Yos said, I think the user means policy routing as well. You can make the specific data only pass one of WAN port. When that WAN port down, the data can go to another WAN. This is what...

You would better to confirm the NAT throughput of your Router. As I knew, TL-R600VPN V1-V3 supports up to 130Mbps because this is its NAT-throughput. We should know that negotiation speed is not...

It's recommended to set channel bandwidth as 20MHz. The bigger bandwidth, easier to be interfere. If you can scan the nearby channel, you can set the channel to a more clean channel. It's good way to...

@Yos For your first question, you can use Policy Routing function to make the traffic pass only single WAN. It can work with load balance at the same time. It's based on IP address and TCP/UDP port....