@MikkelDK It could be set at either the Device or Deco.. if you have no access to the device driver then the Deco app is your likely option. Just check nothing QOS or rate limiting has been enabled....

Yeah this issue appears to have manifested since the 4.2.8 update.. Hopefully this will address it :)

@Mefra Hey again These profiles are updated along with the firmware, it could be wrong. Make sure you are running a 2020 firmware, there was a beta version around July.. been running it for 6m with...

@MikkelDK Hey again The first thing that jumps at me is your up speed is 80mbps and higher than your down, this should deffinately not be the case. As its only happening on this one device I would...

Hey Yeah would totally agree that the R605 has much more functionality when standalone vs SDN managed. To be honest I have found this with my EAP245s and 2008P switch also. There is enough...

@NeilB Hey Neil I have not used v3 of the controller so excuse if this is not the same as v4 - had a look at the emulator for OC200 However i believe you can go to the AP specifically and choose to...