Business Community > Controllers > Omada Hadrware Controller does not Boot after Upgrade
< Controllers

Omada Hadrware Controller does not Boot after Upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada Hadrware Controller does not Boot after Upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada Hadrware Controller does not Boot after Upgrade
Omada Hadrware Controller does not Boot after Upgrade
2021-09-16 07:32:23 - last edited 2021-09-16 17:18:12
Model: OC200  
Hardware Version: V1
Firmware Version:

Hi everybody,

 

I upgraded today my Omada OC200 Hardware Controller to the newest version.

 

After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.

 

Did anyone have the same problem oder can help me to solve the problem?

 

Thank you!

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Omada Hadrware Controller does not Boot after Upgrade-Solution
2021-09-16 10:49:40 - last edited 2021-09-16 17:18:12

Dear @Christian2705,

 

Christian2705 wrote

I upgraded today my Omada OC200 Hardware Controller to the newest version.

After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.

Did anyone have the same problem oder can help me to solve the problem?

 

It seems that the OC200 is bricked, it's suggested to use the recovery mode to recover the firmware.

[Solution] How to use the Recovery Mode to recover the firmware for Omada Hardware Controller

 

Here is the download link for the new firmware of OC200: OC200_v1_1.9.1_Build 20210721

Best Regards!
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Omada Hadrware Controller does not Boot after Upgrade-Solution
2021-09-16 10:49:40 - last edited 2021-09-16 17:18:12

Dear @Christian2705,

 

Christian2705 wrote

I upgraded today my Omada OC200 Hardware Controller to the newest version.

After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.

Did anyone have the same problem oder can help me to solve the problem?

 

It seems that the OC200 is bricked, it's suggested to use the recovery mode to recover the firmware.

[Solution] How to use the Recovery Mode to recover the firmware for Omada Hardware Controller

 

Here is the download link for the new firmware of OC200: OC200_v1_1.9.1_Build 20210721

Best Regards!
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 8

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.