CPE710 not transmitting full internet bandwidth
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I've recently installed a CPE710 with default settings, and everything seems to work properly. However, I cannot seem to exceed an bandwidth of 90mbps, when my internet provider provides 400mbps. To troubleshoot, I took the LAN cable that is going into the CPE710, and connected it to my computer - and my computer received the full 400mbps. I assume this means everything is "ok" from a hardware configuration standpoint. Then, when I plug it back into the CPE710, the max I receive is 90mbps at point blank range. I have two CPE710s and both get the same results. I assume this means the issue is software? What could be going on? Is there anything I should try?
You have 400 full speed from the Ethernet cable. Meaning your port is 1 gig and the computer's 1 gig. CPE710 has a 1 gig port, too.
Here's the issue. If you test the wireless, you may get 90Mbps. I think you need to change the wireless bandwidth > channel width. Make it to 40MHz or 80Mhz. The default is on auto and looks like you are using 10/20Mhz. You should get higher speed results by doing so. 