Business CommunityWiFiEAP245 - Load Balancing
WiFi

EAP245 - Load Balancing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP245 - Load Balancing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP245 - Load Balancing
EAP245 - Load Balancing
2018-01-31 04:55:42
Model :

Hardware Version :

Firmware Version :

ISP :

Running:
EAP Controller 2.5.4
2x APs EAP245 Firmware Version 1.2.0 Build 20170828 Rel. 67350


I have 2 EAP245's in my home. 1 located upstairs, 1 in basement. I would like for them to hand off from one to the other when signal gets low. Example. Client (iPhone) is connected to basement AP and moves up stairs, it is still connected to basement AP but VERY weak. I would like it to handoff to upstairs AP. Is this something that I would set the RSSI Threshold to handle this or is there something else to set?

Thanks for any help.
0
0
#1
3 Reply
Re:EAP245 - Load Balancing
2018-01-31 17:29:04
Yes, you could try to set a RSSI threshold on the EAP in the basement. Also make sure to use the same SSIDs and same WPA keys on both EAPs, but different WiFi channels. Note that there might be a short delay when a client device is switching APs. Furthermore, if the client device is in sleep mode with WiFi disabled, it will not switch to the other AP until the WiFi adapter becomes active again.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#2
Re:EAP245 - Load Balancing
2018-02-01 04:51:46

R1D2 wrote

Yes, you could try to set a RSSI threshold on the EAP in the basement. Also make sure to use the same SSIDs and same WPA keys on both EAPs, but different WiFi channels. Note that there might be a short delay when a client device is switching APs. Furthermore, if the client device is in sleep mode with WiFi disabled, it will not switch to the other AP until the WiFi adapter becomes active again.


Thanks,

I use the EAP Controller software to manager my APs. I think it manages the SSIDs and channels for me. Any recommendation on threshold?
0
0
#3
Re:EAP245 - Load Balancing
2018-02-02 20:41:05

dhill835 wrote

I use the EAP Controller software to manager my APs. I think it manages the SSIDs and channels for me. Any recommendation on threshold?


The EAP Controller just sets SSIDs/channels as configured by you. You can think of EAP Controller as a central management for all EAPs, but you still have to set the SSID/channel it should configure the EAPs to.

Threshold depends on actual signal strength which you want to trigger a forced re-connect. Using a WiFi analyzer on the phone while being upstairs helps you to find out the correct threshold for the basement EAP at which the phone should be forced to re-connect with the upstairs EAP.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#4

Information

Helpful: 0

Views: 1

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.